User Manual

8
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour
l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage adioélectrique
à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la
puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à
l'établissement d'une communication satisfaisante.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
cm between the radiator and your body. This transmitter must not be co-located or operated in
conjunction with any other antenna or transmitter.
Cet équipement est conforme aux limites FCC d'exposition aux radiations définies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé à une distance
minimale de 20cm entre le radiateur et votre corps. Cet émetteur ne doit pas être co-
implantés ou exploités en conjonction avec une autre antenne ou émetteur.
FCC and IC Label Requirements
Label Requirement for the I210+c Module (host board)
There are two transmitters on the I210+c module, the on-board Zigbee radio and the S5-MCM0
module. Both are modular certified. The label requirement is as follow.
A label placed on the I210+c module with the following information is required for the S5-
MCMO. This is required because the S5-MCM0 does not come with a FCC/IC label of its own.
See location LBL5 in the figure below. The model name is not required.
Contains FCC ID: R7PNG0R1S7
Contains IC: 5294A-NG0R1S7
A label with the following information is required for the Zigbee radio. See location LBL4 in the
figure below.