User Manual

Landis+Gyr Endpoint Quick Start Guide
Quick Start Guide 98-2412 Rev AA 5
• Module, ZigBee and Metrology firmware can be upgraded via the network
• Metrology firmware can also be upgraded over the optical port
• Normal operation during upgrades (displays blanks momentarily during F/W Flash)
• Meter software remotely and locally readable
• Remote or local load side voltage test
• Self-reads occur at midnight for each register
• Support for 12 self reads
TOU/Recorder
• 8-channels of load profile
• Interval data of 1, 5, 15, 30 and 60 minutes
• Interval data collection for energy consumption
• Meter distinguishes between missing interval and zero consumption
• Meter distinguishes between power outage and zero consumption
• 5-minute interval data is available for a maximum of 45 days for two channels
• Over-the-air-flashable firmware
• Module, ZigBee and Metrology firmware can be upgraded via the network
Meter Configuration Support
Consult Landis+Gyr 1132COM/1132Prog documentation or contact your Landis+Gyr distributor for
details on programming the Landis+Gyr meter.
Net Metering
Gridstream RF G5 FOCUS AXe endpoints also support the use of the Landis+Gyr meter for net
metering usage in metrology values with 5-dial reads or greater. Net metering allows the endpoint to
report the net power flow of energy in both directions when power is generated locally at a cus-
tomer’s site (wind, solar, etc.).
Figure 1 - 3. Enabling Net Metering
Draft 10/7/2015