User Manual

Quick Start Guide Landis+Gyr
4 98-1482 Rev AA Quick Start Guide
Contact your Landis+Gyr distributors for documentation and details on programming the FOCUS
AXe meter.
About the LAN ID
The LAN ID is a unique identifier for each Landis+Gyr endpoint and it is always displayed in hex
values. Landis+Gyr provides the LAN address. You cannot change the LAN ID of an endpoint.
Labels
The endpoint includes the following labels:
Figure 2. Label Identification
Demand (TOU Capable)
• Peak demand
• kWh, and kW demand (TOU capable)
• Bi-directional measurement
• Remote disconnect and reconnect capabilities on the FOCUS AXe Service Disconnect meter
• Display and registers powered with disconnect switch in the open position
• Detects, logs and reports program or memory failure
• Module, ZigBee and Metrology firmware can be upgraded via the network
• Metrology firmware can also be upgraded over the optical port
• Normal operation during upgrades (displays blanks momentarily during F/W Flash)
• Meter software remotely and locally readable
• Remote or local load side voltage test
• Self-reads occur at midnight for each register
• Support for 12 self reads
TOU/Recorder
• 8-channels of load profile
• Interval data of 1, 5, 15, 30 and 60 minutes
• Interval data collection for energy consumption
• Meter distinguishes between missing interval and zero consumption
• Meter distinguishes between power outage and zero consumption
• 5-minute interval data is available for a maximum of 45 days for two channels
Draft 10.8.14