User Manual

Gridstream RF Enhanced Integrated FOCUS AX Quick Start Guide Landis+Gyr
4 98-1033 Rev AB Data Sheet
About the LAN ID
The LAN ID is a unique identifier for each Gridstream RF endpoint. It is always displayed in hex.
Landis+Gyr provides the LAN address. You cannot change the LAN ID of a radio.
HAN Support
The Gridstream RF Enhanced Integrated FOCUS AX communication module supports an integrated
ZigBee system on the chip. This enables the endpoint to communicate via Smart Energy Profile 1.0
with other ZigBee enabled devices.
Endpoint Registration with Command Center
Communication module firmware version 6.x or later and module Device Control Word (DCW)
1A01.06.05 or later is required for auto-registration. After the endpoint is installed in the field it will
automatically register with the Head End System. No special tools are needed during installation as
the normal Utility meter swap process can be utilized.
The meter automatically sends in the registration information containing items on how the meter/
endpoint is configured so the host can properly interpret the incoming data. Some of the items
contained in this are as follows:
• Default collector/destination
• Reporting interval for Register Data
• Reporting interval for Interval Data
• Meter's AMR-level security password
• Time Synchronization parameters
• GMT offset
• Periodic Register Data reporting
• Periodic LP Data reporting
• Meter configuration information
Once this information has been sent the endpoint starts collecting and sending based on the default
configuration loaded during manufacturing.
Retrieving Data
The endpoint is capable of delivering data via an On Request Read (ORR) or autonomously
(periodically reported).
Availability of the following features depends on meter configuration. On Request Reads (ORR)
available with this endpoint are:
• Register Data (Standard Table 23) which includes consumption, demand and TOU values
• Load Profile or Interval Data (Standard Table 64)
• Revenue Integrity Services which includes instantaneous measurements related to line
voltage, current and phase angle