User's Manual

oÉëáÇÉåíá~ä=jÉíÉê=jçÇìäÉ=oÉíêçÑáí
`ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ RJT
9UtilizetheRFBustertoverifymoduleistransmitting,holdtheRFBusterwith
magnetsidetothetopupperleftquadrantofthemoduleplasticcoverand
holdthebuttonuntil10beepsarereceived.SeeAppendix C
,UsingtheRF
Busterformoreinformation.
Figure 5.12 American: Meter module with cover and tamper seals installed
10 InstallthecoverontheMeterModulebase,usingthefourscrewsthatwere
provided.Tightenthescrewsuntilthecoversitssnug,thentightenan
additionalquarterturn.
11 Installnewredtampersealsovertwodiagonalscrews(upperrightandlower
left,orupperleftandlowerright).
12 Cleanupanydebrisfr
omtheretrofitandinstallationprocesses,andleavea
doorhangertagwithanyappropriateinformationfilledin.Makesureto
alwaysleaveadoorhanger.
13 Attheendoftheday,theinstallerreturnstotheCrossDockforthecheck‐in
process.Theinstallershouldalsoturnininv
entoryofunu
sed,defective,or
brokengasMeterModules.TheInstallermustcheckinallHandheldsissued.
Theinstallerisresponsibleforreconcilinganydiscrepanciesinchangeddata
beforethecheck‐inprocesscanbecompleted.MetersModuleswillnotbe
checkedouttoaninstallerwhohasnotcompletedthepreviousdayʹscheck‐in
process.
Magnetlocation
for“busting”