User's Manual

`çããÉêÅá~ä=~åÇ=fåÇìëíêá~ä=jÉíÉê=jçÇìäÉ=fåëí~ää~íáçå
SJNO `ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ
12 Installnewtampersealsovertwoscrewsusingtheplasticsleeveprovided
(optional).
Figure 6.20 Rockwell/Equimeter/Sensus: center test dial, counter installed, or index
13 UtilizetheRFBustertoverifymoduleistransmitt ing,holdRFBusterwith
magnetsidetothetopupp erleftquadrantof themoduleplasticandholdthe
buttonuntil10beepsarereceived.SeeAppendix C
,UsingtheRFBusterfor
moreinformation.
14 Cleanupanydebrisfromtheretrofitandinstallationprocessesandtieany
loosecableswithtiewraps.
15 Proceedtothenextinstallationsite.
16 Attheendoftheday,returntotheCrossDockforthecheck‐inprocess.Turn
ininventoryofunused,def
ective,orbrokengasMeterModules.Checkinall
handheldcomputersissued.Youmustreconcileanydiscrepanciesinthe
changeoutdatabeforethecheck‐inprocesscanbecompleted.MeterModules
willnotbecheckedouttoaninstallerwhohasnotcompletedtheprevious
dayʹscheck‐inprocess.
Sprague/Actaris Meter Module Installation
Figure 6.21 Sprague/Actaris: Indexes before installation