User's Manual

`ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ SJN
CHAPTER 6 COMMERCIAL AND INDUSTRIAL METER MODULE
INSTALLATION
Thischapteroutlineschangeoutproceduresfor:
•AmericanCG3
• Rockwell/Equimeter/SensusMeterModuleInstallation
•Sprague/ActarisMeterModuleInstallation
•Schlumberger/ActarisMeterModuleInstallation
RefertoAppendix E
,Difficult/Non‐compatibleCommercialRetrofitsfordifficultand
non‐compatiblemoduleinstallationinstructions.
TO BEGIN C&I METER MODULE INSTALLATION
Thefirstfourstepsforeverygasmetermoduleinstallarethesameforevery
manufacturer.Priortobeginningthecommercialmetermoduleretrofit,make
sureyouhavefollowedthestepsinʺIftheinstallerscomeacrossanymeterswherea
medicalalertcodeappearsintheHandheldforthataddresstheyar
etodi
scontinuethe
exchange,entertheappropriateskipcodeandmovetothenextexchange.PriortoMeter
ExchangeorModuleRetrofitʺonpage 3‐1.
1RemovethecoverfromtheMeterModule.
2Plugthe p rogrammingcablefromtheHandheldintotheprogramming
powercableontheMeterModule.RefertoChapter 2
,UsingtheHandHeld
Device.
3ProgramtheMeterModuleandchecktheHandheldforsuccessful
programming(example,Dials=4,MeterID=0123456G,MeterConstant=2).
4Removethetampersealsandindexcoverfromtheoriginalgasmeter.