User's Manual

rëáåÖ=íÜÉ=oc=_ìëíÉê
`ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇ É `JP
IftheRFBusterdoesnotdetectatransmissionfromthemodule,removethefour
coverscrewsandplacetheRFBusterintheproperlocation.Whileholdingthe
PushButton,pullthecoveroffofthemodule.
•Ifthemoduleisfunctional,ittransmits.
•IftheRFBusterdoesnotrespond,consider
themoduledefectiveandfollow
theappropriateprocedure.
Figure C.2 Rockwell/Equimeter/Sensus RF Buster placement
Sprague/Schlumberger/Actaris Modules
1PressthebuttonwiththelightfacingyouonthelowerendoftheRFBuster.
2PlacethecorneroftheRFBustercontainingthemagnetatananglebythe
locationoftheReedSwitchonthegasmetermodule(topleftcorner).
3 Continuetopressthebutton.HoldtheRFBusterwithin
aboutsixinchesof
themeter.ThemagnettriggerstenRFtransmissionsfromthegasmeter
module,separatedbyonesecondeachtransmission.TheRFBusterLED
lightsredandtheinternalspeakersoundsapproximately ½secondforeach
transmissiondetected.
IftheRFBusterdoesnotdetectatransmis
sionfrom
themodule,removethetwo
coverscrewsandplacetheRFBusterintheproperlocation.Whileholdingthe
PushButton,pullthecoveroffofthemodule.
•Ifthemoduleisfunctional,ittransmits.
Because of the proximity of the different switches on the Sprague Module board,
ensure that you approach the module from the top left corner as seen in the
picture below.