User's Manual

rëáåÖ=íÜÉ=e~åÇeÉäÇ=aÉîáÅÉ
OJNO `ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ
Begininstallingthegasmodulebyfollowingtheinstructionsinlaterchaptersof
thisGuide.
Figure 2.12 Handheld Initial programming screen
Programscreendisplaysthemeterinformationandpromptstheinstallerto
connecttothemetermodule.
.
1 ConnecttheHandheldPCtothemetermodule(refertoappropriate
installationprocedure).
2ChecktoensurethattheinformationthatyouenteredintotheHandheldis
correct,suchasdriveconstant,Indexread,andmeterID.Forexample,
dials=4,mete
rID=0123456G,meterconstant=2.
3PressENTERtobeginprogrammingthemetermodule.TheHandheldPC
willdisplaythefollowingscreensduringprogramming:
TheHandheldPCsearchesfortheconnectedmetermodule.Thisprocesswill
takeafewseconds.
Ifthemetermoduleisnotconnected,anerrorscreendisplays.Refertoʺ
Special
Casesʺonpage 2‐15formoreinformation.
Table2.7HandheldOptionsandActiveKeysforInitialprogramming
screen
Option or Active Key Function
pí~êí _ÉÖáåë=éêçÖê~ããáåÖ=íÜÉ=ãçÇìäÉ
båíÉê p~îÉë=~åó=ÅÜ~åÖÉë=~åÇ=~Çî~åÅÉë=íç=íÜÉ=åÉñí=ëÅêÉÉåK
bp` oÉíìêåë=íç=íÜÉ=éêÉîáçìë=ëÅêÉÉå