User's Manual

rëáåÖ=íÜÉ=e~åÇeÉäÇ=aÉîáÅÉ
OJQ `ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ
USING THE DAP HANDHELD
ThissectiongoesthroughtheprocessofusingaDAPHandheldforthe
installationofaCellnetreadymeteratacustomeraccount.
Getting Started with the Handheld
Atypicalgasmeterinstallationrouteconsistsofthefollowingbasicsteps:
1Checkoutmeterswithmodulesalreadyinstalledandmetermodulesfor
retrofit.PickupHandheldPCandlabels.Priortometercheckout,the
HandHeldPCisprogrammedforanassignedinstallerandaninstallation
route(accountaddress,currentmeterID,mete
rlocation,etc
.).
2Checkroute.ReviewinstallerIDroutestatus:numberofinstallationsper
routeID,installationscompletedorskipped.
3Checkaccountaddress.Verifyaddressandanyspecialcustomerinformation
uponarrivalatthecustomersite.
4CheckMeterID.VerifythatthemeterIDmatchestheoneintheHandheld.
5En
termeterread.Entermeterreadingfromexistingmeter.
6ScanmeterID.ScanmeterIDfromthechangeoutmeterlabels.
7Installchangeoutmeter.Labelexistingmeterwithachangeoutlabel.Remove
existingmeterandreplacewithchangeoutmeter.
8 Repeatsteps3to7foreachaddress.
9Checkinreplacedmeters.Returnthem
totheCross‐Dockanddockthe
HandheldPC.