Installation Guide Part 2

d~ë=jÉíÉê=mêÉé~ê~íáçå=mêçÖê~ã=EdmêÉé F
VJOS `ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ
Figure 9.23 Error Message Displayed when Entered Value Does Not Match Programmed Value
Ifyouselect“Yes”,GPrepdisplaysablinkingmessagestating“Dialdiscrepancy”
andthemainscreendisplaysthatthenewdialvaluehasbeenloggedinMRBlog.
ThisiscapturedintheMRBlogas“dialEntered”.GPrepdoesnotcapturetheold
valuethatwasprogrammedintothemodule.
Ifyouselect“N
o”,GPreppromptstheoperatortoenterthecorrectvalue.
UponacceptanceofenteredvaluesforLANAddressanddial,GPrepcreatesa
recordintheMRBincludingtheclosingindexreadand“DialVerified”in
additiontotheassociationrecords.
Thedialfieldrequiresthenumberofdigitsthatcorrespondtotherolloverpoint
previouslyprogrammedint
othemodule.Example:Iftherolloverpointissetat
1,000,thenafourdigitdial(orless)readwouldneedtobeentered.The index
musthavefourdialsiftherolloverpointof10,000iscorrect.Iftheindexread
numbercontainsmoredi
gi
tsthancorrespondingrolloverpoint,GPrepdisplaysa
message“enteredvaluecontainstoomanydigits”promptingthe operatortore‐
entertheindexreadandablinkingmessageinthemainscreen“dialrejected”is
alsodisplayed.