Installation Guide Part 2

d~ë=jÉíÉê=mêÉé~ê~íáçå=mêçÖê~ã=EdmêÉéF
`ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ VJNT
MODULE PROGRAMMING
Therearetwomodesforprogrammingthemodules.ProgramNewisusedwhen
amoduleisinstalledonanewmeterwithanindexthatreadszero,andRe‐
programoldisusedforprogrammingamodulethatisbeinginstalledonameter
thathasanindexwithavalueothertha
nzero.Thisva
lueisprogrammedintothe
moduletologinthestartingreadforametertobeinstalled.
(Anexampleofthisisaperiodicmetercheckinwhichameteristakenfroma
residence,inspectedandthenre‐deployedagainintoanotherresidence).
Program New
1SelectProgramnewfromthemodedropdownwindowinthemainmenu.
Thefollowingscreendisplays.
Therearetwodistinctsectionsinthisscreenasw ell.Thetopsectioncontainsthe
followingfieldswhichcanbemodifiedbytheuser:
•MeterIDfield
•LANAddress
•Roll‐overpoint
•Meterconstant.
Figure 9.11 “Program New” Screen
If you are programming a Water CPR module, Device ID replaces Meter ID. A CPR module is
programmed with 10-digit left-justified(zero) Module ID as MeterID. Water CPR
programming also captures optional Encoder ID information.