Installation Guide Part 2

`ÉääåÉí=mìäëÉ=oÉÅçêÇÉê=jÉíÉê=jçÇìäÉ=fåëí~ää~íáçå
`ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ TJR
FCC INFORMATION
SeeAppendix F,CPRInform ation ,formoreinformation.
INSTALLING THE CELLNET PULSE RECORDER
ThefollowingincludesinformationaboutinstallingtheCPRendpoint.
Mounting the CPR
TheCPRendpointshouldbemountedaboveground,outdoors,facingthenearest
concentrator.
Identifying the Register for Installation
RefertotheGasModuleCompatibilityChartforcompatibilityandspecificparts
needed.
Connecting the PRECO Switch to the CPR
1InstallthePRECOswitchonthegasmeterindexaccordingtotheinstructions
includedwiththePRECOkit.
2RoutethecablefromthePRECOswitchtotheCPRmountinglocation.Splice
theadditionalcableasnecessary.Whenusingadditionalcable,alwaysmatch
colors:PRECObluetoCPRwhite(viagreenextensionwire),PRECOre
dto
CPRre
d,PRECOwhitetoCPRblack(viablackextensionwire).
3Ifyouneedtoaddcableforaremotewall‐mountedCPR,followthe
instructionshereforremovingtheMolexconnectors(ifpresent)andsplicing
additionalcable.Preparecableendsforcrimping:
aUsingthecuttingbladeportionoftheWireCutterandStrippertool,cut
thewi
reattheMolexconnector(ifpresent)comingfromthePRECO
switch.ThewireattachedtothePRECOswitchcontainsthreewires.
Figure 7.1 3-Wire Cable
Do not damage internal wire insulation when removing external insulation.