Installation Guide Part 1

oÉëáÇÉåíá~ä=jÉíÉê=jçÇìäÉ=oÉíêçÑáí
`ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ RJR
7 AttachtheindextotheMeterModule housingwiththecapturedclipsonthe
standoffscrews.Besurethattheclipsareextendedfullytowardstheoutside
edgeofthemodulewhenyoufittheindextothemodule,andaligntheindex
dogoftheindextothemoduleʹswiggler.Pu
shthetwoclipstowa rdsthe
insideofthemoduletosecuretheindex.Aftertheindexisinstalled,the
installermustturntheprovingdialontheindextoensuretheindexis
properlyengagedwiththemodule.
Figure 5.7 American: Installing Index on standoff screws
Figure 5.8 American: Sliding the Index clip in
Use torque screwdriver set at 10 inch-pounds to install the two captured standoff screws
for all module installations.