User Manual

Chapter 2 - GPR2-PT Mounting Instructions Landis+Gyr
16 98-1678 Rev AA Installation Guide
Figure 2 - 11. Mercury Mini-Max Interior
1. Insert serial cable (19-2380) through the appropriate cable port. If the port is filled with a cap,
replace with 16-1704 or any similar, water-tight cord grip that will fit a 0.33 inch diameter cable
(e.g. Mercury PN 20-8911).
2. Pull the cable through the port far enough to reach the connector and drain hardware.
3. Attach the cable leads into the J4 connector of the PT board (Mercury PN 40-3812) using a small
flathead screwdriver to tighten the wires. Use the wiring diagram below.
4. Using a screwdriver or slip joint pliers, attach the drain terminal to an appropriate screw or nut
for proper grounding. Some common examples are shown in Figure 2 - 12 through Figure 2 - 13
below.
5. Once the connections are secure, make sure the cord grip is sufficiently tightened on the cable.
Figure 2 - 12. Drain Locations in Mini-AT