User Manual

Landis+Gyr Chapter 2 - GPR2-PT Mounting Instructions
Installation Guide 98-1678 Rev AA 13
GPR2-PT Mounting Instructions
Eagle Cable Entry
Figure 2 - 6. Eagle Corrector Wiring
1. Insert serial cable (19-2380) through cable port shown. If port is filled with a cap, replace with
16-1705 w/ 16-1706 or any similar, water-tight cord grip that will fit a 0.33 inch diameter cable.
2. Pull the cable through the port, far enough to reach the connector and drain hardware.
3. Attach the cable leads into the TB8 connector using a small flathead screwdriver to tighten the
wires. Use the wiring diagram below.
4. Using a Phillips screwdriver, attach the drain terminal to the proper location.
5. Once the connections are secure, make sure the cord grip is sufficiently tightened on the cable.
Connector
Cable PortDrain Screw