User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Chapter 3 - Using Endpoint Testing Manager (ETM) Landis+Gyr
72 98-1671 Rev AA User Guide
Figure 3 - 41. Universal Event Log Tab
Figure 3 - 42. Generate Report Data View
Groups Tab
The Groups tab is only enabled on meters with version 422 or higher firmware. This tab allows
organizing meters into groups so as to enable actions and activities that are group-based.
NOTE: A meter can belong to no more than eight groups.