User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Landis+Gyr Chapter 3 - Using Endpoint Testing Manager (ETM)
User Guide 98-1671 Rev AA 71
Figure 3 - 40. Fully-Populated HAN Tab - “Publish Price” sub-tab displayed
A CAUTION: View the Connection tab. Click the check-boxes for both Enable Field Mode and
Display Scrolling Status. Click Save Settings. These settings will continue to be the default
setting each time ETM is launched.
Universal Event Log Tab
The Universal Event Log tab, shown in Figure 3 - 41, enables user-programmable log activities that
result from meter events.
Table 3 - 12. Universal Event Log Tab
Field Description
Start Date The user-programmable start date parameter.
Start Event ID This parameter can be set from 1 to 254.
End Date The user-programmable end date parameter.
End Event ID This parameter can be set from 1 to 254.
Event Report Type
Set by the user to specify either Log Only, Advisory Only, or Alarm Only
Report Types for meter events.
Generate Report <button>
Generates a report based on meter events, with options for setting up
report appearance and saving these reports.
Activity Log
Insert Comment <button>
Allows a user to insert comments into the Activity Log. These time-stamped
comments will also list in the Log file.