User Manual

Chapter 3 - Using Endpoint Testing Manager (ETM) Landis+Gyr
68 98-1671 Rev AA User Guide
Command Schedule
The Command Schedule interface provides the user with the ability to schedule up to 12 specific
commands, stipulate parameters for the scheduled commands, and set the Erase Control (this value
must be set before sending any command). Drop-down arrows next to each parameter allow these
commands to be programmed for specific dates and times and set to function in varying ways.
Figure 3 - 36. Some Command Scheduler Command Types
Figure 3 - 37. Command Scheduler Calendar
Figure 3 - 38. Command Scheduler Test Interval Types
Figure 3 - 39. Command Scheduler Test Interval Settings
Log Only
The event will be stored in the event log; it will not be reported in alarm/alert
messages; only an on-request read of the event log will retrieve these
events.
Advisory
An advisory message is generated when the specified event occurs; the
event will be stored in the event log and will only be reported the next time a
periodic push is transmitted; the periodic push will track the last event
pushed to the host and will only send events that have not yet been pushed.
Alarm
The event will be stored in the event log and an immediate alert message
will be transmitted.
Table 3 - 10. Event Mask Events (Continued)
Event Mask Field Description