User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Landis+Gyr Chapter 3 - Using Endpoint Testing Manager (ETM)
User Guide 98-1671 Rev AA 67
Figure 3 - 34. Command Scheduler Tab
Event Mask
The Event Mask interface of the Command Scheduler tab supports user notification for specified
events. These events include Primary Power Down, Primary Power Up, Procedure invoked, Table
Written To, Event log cleared, Rate Change, and many others. There are over 90 Event Mask choices
available for notificatio.To view currently-loaded meter commands and their status, click the Get
Scheduled Commands button.
Figure 3 - 35. Command Scheduler Event Mask Notification Options
Activity Log
Insert Comment <button>
Allows a user to insert comments into the Activity Log. These time-stamped
comments will also post to the Log file.
Table 3 - 9. Command Scheduler Tab(Continued)
Field Description
Table 3 - 10. Event Mask Events
Event Mask Field Description
Disabled
No notification when the specified event occurs; the event is not stored and
will not be reported.