User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Chapter 3 - Using Endpoint Testing Manager (ETM) Landis+Gyr
62 98-1671 Rev AA User Guide
• Lock the port indefinitely
• Unlock the port for <user-specified> minutes
• Unlock the port indefinitely
After a choice has been selected from the drop-down menu, the Send button executes the command.
An illustration for the available Optical Lockout functions appears below.
Figure 3 - 30. Optical Lockout Drop-down Menu
For the “X Minutes” selection, a data entry field appears for the user to enter the desired value, after
which pressing the Send button, as with the other options, executes the command.
Reporting Tab
The Reporting tab is comprised of the Meter Information, ANSI Tables and Reports fields. The
fields on this tab are only enabled if a meter test has been run and has a status of Passed.
The table below describes the fields on the Reporting tab.
Table 3 - 8. Reporting Tab
Field Description
Meter Information
Meter Configuration Check-
box
Loads tables to display meter specific configuration parameters (e.g. load
profile, interval length, channel selection).
“Landis+Gyr Meter
Configuration” Check-box
Loads information about proprietary configuration parameters (time sync
configuration, etc.).
LP Data Check-box
Loads tables that display the last two blocks of load profile data (interval
data).
Energy and Demand / TOU
Check-box
Loads Time-Of-Use tables for meter register data.
Demand Reset Data / TOU
Check-box
Loads Time-Of-Use tables for meter demand data.
Meter History Log Data
Check-box
Loads tables that displays the meter history.
Latest Snap Read Check-
box
Loads tables for meter time-of-use data.
Vector Data Check-box Loads tables containing instantaneous meter data.
Meter Event Log Data
Check-box
Loads tables that display the meter events that have occurred.
Status Summary Check-box
Loads a table that displays disconnect switch status and meter time sync
information.