User Manual

Landis+Gyr Chapter 3 - Using Endpoint Testing Manager (ETM)
User Guide 98-1671 Rev AA 61
Figure 3 - 29. Module Tab
Optical Lockout
For compatible endpoints, a section that appears on ETM’s Module tab is active, as seen in the
previous figure. (Endpoints that do not support this feature will display this function, but it will be
“grayed out” to represent connection to an incompatible endpoint).
This setting includes options to:
• Get current status
Set Time
Sync Meter and Module
Time <button>
On connected meters with applicable firmware, this button is enabled after
the Get Time Delta button is clicked and the resulting report is closed. Once
enabled, clicking this button synchronizes meter time with module time. After
Meter and Module Time are synchronized, “Time Sync Completed” will
display in the Set Time box.
Command
Optical Lockout
When connected to compatible meters with applicable firmware, allows the
user/tester to configure the meter’s Optical Lockout parameter. This setting
includes options to:
Get current status
Lock the port indefinitely
Unlock the port for <user-specified> minutes
Unlock the port indefinitely
There is also a button to Send the command to the connected meter.
When the time parameter command is used, a data entry field appears for
entering the Minutes parameter.
Activity Log
Insert Comment <button>
Allows a user to insert comments into the Activity Log. These time-stamped
comments will also post to the Log file.
Table 3 - 7. Module Tab(Continued)
Field Description