User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Landis+Gyr Chapter 3 - Using Endpoint Testing Manager (ETM)
User Guide 98-1671 Rev AA 59
The table below describes the fields on the Firmware Download tab.
NOTE: Field visibility on the Firmware Download tab will vary according to current module firmware
version. There may be limits on firmware administration access with endpoints running module
firmware previous to v6.x.
Table 3 - 6. Firmware Download Tab
Field Description
Download Status
Firmware Download Progress
Displays the percentage status of a firmware download after the Start
Download button is clicked.
Module: Version <Firmware Version Number>
Upgrade To: Drop Down Box
Displays the module firmware upgrade versions that are available to and
supported by the endpoint tested.
The current firmware version is displayed in the title of the field. For
example, Module: Version 251581-06.08
Download Delay Rate (In
Secs) Drop Down Box
Specifies the delay (in seconds) between sending firmware packets. For
large files, you can break up the firmware information that is sent between
the radio and the module and ensure that network bandwidth is not
overwhelmed.
Start Download <button>
Clicking this button will begin downloading the firmware version specified
in the Upgrade To: drop down box to the module.
Meter: Version <Firmware Version Number>
Upgrade To: Drop Down Box
Displays the meter upgrade firmware versions that are supported by the
endpoint tested, and a list of the minimum and maximum meter firmware
versions that the connected meter must be running in order to download
the metrology firmware.
The current firmware version is displayed in the title of the field. For
example, Meter: Version 5.34.3
Download Delay Rate (In
Secs) Drop Down Box
Specifies the delay (in seconds) between sending firmware packets as
described in Module <F/W Version #> above.
Start Download <button>
Clicking this button will begin downloading the firmware version specified
in the Upgrade To: drop down box.
ZigBee: Version <Version Number> (displays when connected to a ZigBee-capable meter)
Upgrade To: Drop Down Box
Displays the module ZigBee versions that are supported by the endpoint
tested.
The current version is displayed in the title of the field. For example,
ZigBee: Version 061411-01.04.02
Activity Log
Insert Comment <button>
Allows a user to insert comments into the Activity Log. These time-
stamped comments will also post to the Log file.