User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Landis+Gyr Chapter 3 - Using Endpoint Testing Manager (ETM)
User Guide 98-1671 Rev AA 55
Figure 3 - 22. Device Test Tab with Endpoint and Service Settings active
High Speed (115200 bps) Enable
High Speed operation (also referred to as Wide Channel Mode) refers to configuring
communications for 115200 bits-per-second data transmission.
Table 3 - 5. “Find Device” Dialog Parameter Details
Field Description
Network Address
The ID number, in decimal and hex formats, of the network that the radio under
test is currently connected to.
WAN Address
Latitude
The latitude of the radio, expressed in:
deg — Degrees
min — Minutes
sec — Seconds
msec — Milliseconds
N/S — North or South
Longitude
The longitude of the radio, expressed in:
deg — Degrees
min — Minutes
sec — Seconds
msec — Milliseconds
N/S — North or South
Color
The parameter that differentiates multiple radios installed at one location (that is,
sharing one WAN address).
Decimal Degrees The WAN address of the radio, expressed in decimal degrees.
Encoded Value (six
bytes)
The same WAN address as that specified by the Latitude, Longitude, and Color
values.