User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Chapter 3 - Using Endpoint Testing Manager (ETM) Landis+Gyr
54 98-1671 Rev AA User Guide
Mode Settings
Current Mode
Current mode of the IWR connected to the meter under test. The user may
change the mode as needed.
(If you are connected through a Collector, your IWR is always in Field Mode.)
Go to <Mode> <button> Sets the radio to Shop Mode or Field Mode
Set Endpoint to <Mode>
<buttons>
Sets the endpoint to either Shop Mode, Field Mode, or Installation Mode
(if Firmware version is 421 or above), depending on the current state.
With v6.x firmware, Set to Installation is the only enabled mode. Setting an
endpoint to Shop mode is only enabled by a key provided by Landis+Gyr.
Endpoint Settings
Set
AMR Password <button>
This button allows you to set the AMR password for endpoints being tested.
Configure Encryption
<button>
This button opens a dialog used to enable or disable encryption on the
meter tested.
Disable Routing <button> This button disables routing through the meter being tested.
Service Connect/Disconnect (only visible when the tested meter has an integrated switch)
Connect <button> Closes the switch (energizes).
Arm <button> Prepares the switch to be closed.
Disconnect <button> Opens the switch (deenergizes).
Get Status <button> Populates the Disconnect Switch section.
Activity Log
Insert Comment <button>
Allows a user to insert comments into the Activity Log. These time-stamped
comments will also appear in the Log file.
Table 3 - 4. Device Test tab(Continued)
Field Description