User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Landis+Gyr Chapter 3 - Using Endpoint Testing Manager (ETM)
User Guide 98-1671 Rev AA 51
Figure 3 - 19. Head End Radio Tab
Reboot <button> Clicking this button restarts the radio’s main board.
Modify <button>
According to radio type, clicking this button allows the user to edit radio
parameters.
<Connection Status>
Displays the connection status. The different statuses are:
Connection Successful
Not Supported Meter Device
Failed Connection
Commands
Get WAN Nodes List
<button>
Queries the radio for a list of neighbors and displays these statistics in a
dialog box.
Clear WAN Nodes List
<button>
Deletes all entries from the current WAN Nodes List so that the radio can
refresh the roster of neighbor radios.
Test Device <button>
Allows users to test the head-end radio (whether it's a serial head-end or
Collector head-end radio), after connecting to the head-end using the
Connection tab. This button will test the link to the connected head-end.
After the connection is confirmed, the user can perform other tasks with it
i.e. FW/DCW downloads.
Birth Chirp Information (only available if head-end radio is in field mode)
Listen for Birth Chirp for
<secs> <button>
Allows you to power up a meter and test to see if your head end radio can
communicate with the meter. If so, the Network ID and mode will be
displayed to ensure accurate testing. Use this button to discover a meter’s
CRC and operational mode.
Activity Log
Insert Comment <button>
Allows a user to insert comments into the Activity Log. These time-stamped
comments will also list in the Log file.
Status Bar
Connected to... Identifies Authentication Server connection and Security Mode.
MAT Certificate Countdown Displays a time-remaining countdown for the current MAT Certificate.
Table 3 - 3. Head End Radio Tab
Field Description