User Manual

Chapter 3 - Using Endpoint Testing Manager (ETM) Landis+Gyr
50 98-1671 Rev AA User Guide
Figure 3 - 17. Connection Selection drop-down
After Collector has been selected, the endpoint drop-down populates with the previous connected
endpoint’s identifier. To select a different Collector, click the drop-down arrow.
Figure 3 - 18. Choosing a Collector
Head End Radio Tab
The Head End Radio tab displays information about the head end radio currently in use. The Head
End Radio tab can also be used to configure Head End radio settings..
Table 3 - 3. Head End Radio Tab
Field Description
Collector / Integrated WAN Radio
Radio: Displays radio type.
Encryption: Displays whether encryption is enabled or disabled.
Head-end Can be Enabled or Disabled.
Firmware Version: Firmware version for the head-end radio being tested.
Routing: Displays whether routing is enabled or disabled.
Operational: Displays Operational Bit status as enabled or disabled.
LPP Address:
WAN and LAN address for the radio used in the test. After Modify is clicked,
clicking in this field opens the Configure WAN Address dialog (Figure 3 -
20) and permits the user to specify radio WAN Address parameters. If the
radio is a mobile unit, Routing, Time Keeper, and Collector Bit values
cannot be changed.
Network ID: Network ID for the radio being tested.
Baud Rate: Displays the baud rate of the communications channel.
Typ e :
Displays whether Endpoint Testing Manager is connected to a Serial Radio
or a Collector.
Time Keeper: Enables or disables setting the radio as the timekeeper for the network