User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Chapter 3 - Using Endpoint Testing Manager (ETM) Landis+Gyr
44 98-1671 Rev AA User Guide
Figure 3 - 10. Using the Bar-code Scanner
Navigating the Software
ETM is an easy-to-use software application that allows you to perform specific configuration,
verification, and testing procedures. The application is comprised of an upper menu bar, the tabs
listed below, and a Security Status line at the bottom of the display that describes the server
connection and displays the connected endpoint’s security status.
• Connection
• Head End Radio
• Device Test
• Firmware Download
• Module
• Reporting
• Command Scheduler
• HAN (ONLY appears when a compatible endpoint is connected)
• Universal Event Log
• Service Limiting (ONLY appears when a compatible endpoint is connected)
• Groups
• RF Gas/Water (ONLY appears when the appropriate key is added to the Settings.XML file)
• Collector (ONLY appears when ETM is connected to a Collector)
Use the upper menu bar for exiting ETM, File > Exit, or to display or request Security details (as
specified in the following section).
ETM can also be configured to display an Activity Log at the bottom of each screen that allows the
user to view communication activities between the tool and the endpoint.
Configuring a New Gridstream IWR Radio
These parameters can be set via the Head End Radio tab. To configure a new Gridstream IWR
radio:
1. Connect the IWR to the PC
Table 3 - 1. Upper Menu Bar Security Details
Field Description
MAT Certificate Attributes
Displays details about the Mobile Admin Tool certificate received from
Command Center.
Request MAT Certificate
Sends a request to Command Center for a Mobile Admin Tool
Certificate. Login permissions will vary access to this feature.