User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Chapter 3 - Using Endpoint Testing Manager (ETM) Landis+Gyr
40 98-1671 Rev AA User Guide
After Login: Setup Cautions
NOTE: When ETM is first launched, view the Connection tab. Click the checkboxes for both
Display Scrolling Status and Enable Test Reports, and then click Save Settings. Until changed,
these settings will remain the default each time the ETM application opens.
A CAUTION: Upon launch, ETM will attempt connection to the computer’s first available serial
port. If an Integrated WAN Radio (IWR) is not connected to that serial port, ETM will time out.
After ETM times out, click the Connection tab to select the serial port connected to the IWR.
Certificate Attributes
The current status of the Mobile Admin Tool (MAT) Certificate can be viewed in the Security
display.
Figure 3 - 4. Security Menu Options
From the menu options, select Security > MAT Certificate Attributes.
The Token Attributes displays the current status of the MAT Certificate received from
Command Center.
Figure 3 - 5. Token Attributes
• NetWork ID. The Network ID is the utility’s unique Network Identifier. (For endpoints with
v6.x firmware, this parameter cannot be changed in ETM)
• Token Sequence Number. The Certificate Sequence number uniquely identifies the
certificate issued for the MAT session.
• Lan Address Block. The LAN Address Block displays the set of LAN Addresses that the
MAT has been provided to use to communicate with endpoints. LAN Address block consists
of 16 addresses, and are provided each time a certificate is requested from Command Center.
• Token Expiration Time Stamp. Indicates the date and time that the MAT certificate will
expire. The default value is 1440 minutes (one day) and is established in Command Center
Organization Information settings.