User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Chapter 3 - Using Endpoint Testing Manager (ETM) Landis+Gyr
38 98-1671 Rev AA User Guide
• If this launch of ETM is not connected to a server, click the Select a new server link. The
Server List will appear.
Figure 3 - 2. Server List
• Click the name of the desired server in the Server column to highlight it.
• Click Select. The Server List window will close and the selected server will be displayed on
the ETM log in screen.
Adding a New Server
Click Add on the Server List. The New Server window will open.
Figure 3 - 3. Endpoint Testing Manager - New Server
• Server Nickname: Enter a user-defined name for this server.
• Server Location: Enter the physical location of the server.
• Server FQDN: Enter the fully qualified domain name for the server. (see example in the
New Server display).
• Make this my default Authentication Server. Enable this setting to connect to this server
each time this instance of ETM starts.
• Click Submit to add the new server.
Selecting an alternate existing server
An ETM instance may have multiple servers associated to it. When ETM is first started, the server
that has been selected by default will be displayed on the log in screen. The user may choose a
different server, if necessary.