User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Chapter 2 - Command Center Deployment/Configuration Landis+Gyr
36 98-1671 Rev AA User Guide
Figure 2 - 28. HAN Firmware Info
Confirm that a HAN device can communicate with the meter
To confirm if Command Center can communicate with a HAN device or whether a HAN device is
still in communication with its meter, issue the HAN: Ping command. The Ping HAN Device Status
will be returned notifying the user that the Ping Command was issued. To verify that the device was
Pinged, check the history on the Manage Tab as the response from the device will be logged in the
device history.
Figure 2 - 29. HAN Ping Device