User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Chapter 2 - Command Center Deployment/Configuration Landis+Gyr
30 98-1671 Rev AA User Guide
1. Send the HAN: Initialization command to the ZigBee-enabled meter, if not already completed
during 5.6 (or later) Gridstream System Release upgrade.
2. Provision HAN Devices
3. Provisioned devices can utilize the following HAN applications:
A. Usage/Metering Information.
B. Text Messaging.
C. Load Control.
D. Pricing/Rate Information.
4. Remove HAN Devices from Home Area Network:
A. HAN: Delete Device.
B. HAN: Clear Devices.
C. Decommission HAN.
5. Management & Troubleshooting:
A. Meter Swap out process using Decommission HAN.
B. Commission HAN Network for Channel Control.
C. Meter LCD Screen for ZigBee Alerts.
D. Confirm HAN Radio in Meter is Communicating or HAN is set-up.
E. Get information for a specific device.
F. Get FW version for the HAN radio.
G. Confirm that a HAN device can communicate with the meter.
HAN: Initialization
The HAN: Initialization command provides the meter with key information that the Home Area
Network will need to properly communicate metering information to HAN devices. This process
allows the module firmware to flexibly adjust its meter information collection process to work with
any meter or meter program.
NOTE: The HAN: Initialization command is new to Gridstream with System Release 5.6, and
required to be sent to all existing or new Home Area Networks.
Please see publication 98-1188: HAN Initialization and Firmware Transition Guide for more
details on the HAN Initialization process. This document includes the full process, as well as
expected results or potential issues. It is expected that users will leverage this document in parallel to
this user guide.
NOTE: If a HAN command is sent to a meter before the HAN: Initialization command has been
successfully sent to a meter, the HAN command will fail and the HAN: Initialization command will be
sent to the meter in its place. Once the initialization process is complete, the original HAN
command, which was failed, will need to be retried by the user or 3rd party system.
Under the Manage Tab on the Endpoint Information Window, select the HAN: Initialization
command from the drop-down menu and press Send. This will cause the meter to change from a