User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Chapter 2 - Command Center Deployment/Configuration Landis+Gyr
26 98-1671 Rev AA User Guide
Meter Configuration Groups
A Configuration Group is a type of Command Addressing Group. A meter can be a member of only
one configuration group. All members of a configuration group must be assigned the same
configuration settings. Configuration groups are used to drive group-based reconfigurations for
multiple endpoints.
Each endpoint type is manufactured with a default configuration group.
The data transmitted by an RF module, how frequently the data is sent, and how the module
responds to conditions in the field, is dictated by the endpoint’s Configuration Group.
An RF Endpoint configuration consists of the following:
• Packet Definitions that are built for various data elements to be captured by the endpoint.
• Alarm Definitions that establish the priority associated with events that occur in the RF
endpoints.
• RF Network Settings that establish the outage wait and time synchronization settings.
• A schedule that includes the commands and packet definitions, along with time settings and
frequency settings associated with data transmission, that are stored in the endpoint.
NOTE: During the Auto-registration process, the module transmits an Init Push packet which
indicates its configuration. This enables Command Center to associate the endpoint with the
appropriate configuration group. If the configuration transmitted does not match an existing
configuration in Command Center, a new configuration group may be auto-generated to which the
endpoint will be assigned. For this process to occur, the Auto Generate Meter Configuration Groups
setting must be enabled in System Settings.
1. Click Setup > Groups > Meter Configuration Groups and select the endpoint type.
The Configuration Group screen will be displayed.
Figure 2 - 14. Configuration Groups Window
If you wish to view the details of an existing configuration group, perform the following steps.
A. In the Configuration Group window click the View Meters icon for the Configuration
Group you want to view to display the Group Summary window.