User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Landis+Gyr Chapter 2 - Command Center Deployment/Configuration
User Guide 98-1671 Rev AA 25
Alarm Definitions
Alarm Definitions determine what type of response the given Events will trigger, including
Dashboard Alerts and Email Alerts. Alarm Definitions must be created prior to Meter Configuration
Groups in order to be programmed to a module.
1. Click Setup > Alarm Definitions and select the appropriate endpoint type to display the Alarm
Definitions screen.
Figure 2 - 12. Alarm Definitions screen
2. Click the New button to display the Alarm Definition screen.
Figure 2 - 13. Alarm Definition screen
3. Enter an Alarm Definition name in the Name field.
4. Choose the desired setting for each event. See below for setting descriptions.
NOTE: The default Alarm Definition settings represent the recommendation of Landis+Gyr.
5. Click the Save button.
An Alarm Definition can only be edited if it is not already part of an existing Configuration Group.
Available Settings
Result Disabled Log Only Advisory Alarm
Event is:
Logged in module
Available via request
Included in next
Transmitted immediately
Flagged on Dashboard
Included in E-mail Alerts