User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Landis+Gyr Chapter 2 - Command Center Deployment/Configuration
User Guide 98-1671 Rev AA 23
• Number of installed meters that have sent in a billable reading in the last 24 hours (Blue).
Endpoint Configuration
Packet Definitions
Creating a packet definition is necessary to reconfigure the packet payload of an endpoint. Packet
definitions can contain several different user-configurable data elements.
NOTE: RF endpoints allow a user to return up to 6 registers. However, the more registers returned,
the greater the strain on the network.
1. Click Setup > Packet Definitions > RF Residential
The Packet Definitions screen will be displayed.
Figure 2 - 10. Packet Definitions Screen
2. In the Packet Definitions screen (above) click the New button to display the Packet Definition
window.