User Manual
Table Of Contents
- 15-0028 - Exhibit Cover.pdf
- Elster A3 User Guide 98-1671.pdf
- Endpoint Overview
- Command Center Deployment/Configuration
- Deployment
- Tracking and Deployment
- Endpoint Configuration
- HAN Setup Process Overview
- HAN: Initialization
- Provisioning HAN Devices
- Remove HAN Devices
- Management and Troubleshooting
- Meter Swap Out Process using Decommission HAN
- Commission HAN Network for Channel Control
- Meter LCD Screen for ZigBee Alerts
- Confirm HAN Radio in Meter is Communicating or HAN is set-up
- Get information for a specific device
- Get Firmware version for the HAN radio
- Confirm that a HAN device can communicate with the meter
- Using Endpoint Testing Manager (ETM)
- Specifications
Chapter 2 - Command Center Deployment/Configuration Landis+Gyr
22 98-1671 Rev AA User Guide
Figure 2 - 9. RF Installation Status Report
The following information is displayed in the report:
•Day. This number will increment for each day the used has selected to display.
•Date. This will display the dates selected in generation of the report. Click the date link to
view a list of all meters deployed on the selected date.
• Daily Installed. This will display the number of endpoints installed for that particular day.
The daily installed data is imported into Command Center via the Installation File.
• Discovered. Of the total number of meters installed on the summary date, the total number
of those that have transitioned into a Discovered state and the percentage
(Discovered meters/Installed meters).
•Normal. Of the number of meters installed on the summary date, the total of those meters
that have transitioned to a normal state at that point in time and the percentage (Normal
meters/Installed meters).
• Readings. Of the total number of meters installed on that day, the number of those meters
that have sent in a billable reading packet, and the percentage (meters that have sent a
billable reading packet/total meters installed on that day).
• Readings past 24 Hours. Of the meters that were installed on that day, the total number of
meters that sent in a billable readings packet in the last 24 hours (from the point the report
was generated) and the percentage (meters that sent in a billable readings packet in the last
24 hours/total meters installed on that day).
• Cumulative installed. The total number of meters that have been installed up to that date.
•Normal. The total cumulative number of meters that have transitioned to Normal status up
to that date.
The color-coded bar graph displays the following deployment information:
• Cumulative number of meters installed for each date (Grey).
• Current number of meters that have transitioned to Normal status (Green).