User Manual

Landis+Gyr Chapter 2 - Command Center Deployment/Configuration
User Guide 98-1671 Rev AA 21
to space limitations. By clicking on a specific date, each endpoint registering that day displays
installation, registered, normal and reading status for this date. Information on the report is updated
as the information is received by Command Center on a rolling seven day basis. Installation
information is populated from the RF Installation File Import process. Registered and Normal status
updates are based on receipt of the two registration requests from the endpoints. Readings are based
on the first reading received from the endpoint. Average deployment time is based on the time it
takes to go from installed to normal.
5. Click on the Date link to display the Gridstream Meters Deployed By Day report.
Figure 2 - 7. RF Meters Deployed by Day
RF Installation Status
The RF Installation Status Report is intended to be used by utilities during mass deployment. It can
be used as an installation tool to determine how many meters have been installed over a specified
time frame and of those meters how many have been discovered, how many have moved to normal
status, how many are sending readings, and how many have sent readings in the past 24 hours.
Following is the procedure for viewing the RF Installation Status report:
1. From Command Center, select Network > RF Installation Status. The RF Installation Status
window will open.
Figure 2 - 8. RF Installation Status
2. Selection Criteria. Select All to view results for all collectors in the system
...or...
Select the desired collector from the drop down box to view results for only that collector.
3. Date Range. Enter a Start Date and End Date. Select the Calendar icon to view a calendar and
make date selections if needed.
4. Click OK. The RF Installation Status report will be displayed, shown in Figure 2 - 9.