Installation Guide

`ÉääåÉí=i~åÇáë=H=dóê=pQÉ=dÉå=ff=ríáäákÉí=jçÇìäÉ=qÉÅÜåáÅ~ä=oÉÑÉêÉåÅÉ=dìáÇÉ OJN
CHAPTER 2 FEATURES AND FUNCTIONS
UsingtheLandis+GyrS4ewith2Gmodule,youcan:
•Integratemoduleintoallforms,classesandvoltagesofthe S4Emeter
• Communicateviaserialconnectionbetweenthemoduleandthemeter
throughthemeterʹsprovidedinterface
• Supportalllevelsofmeterpasswords
• Downloadradiofirmware
Communicating via Meter to Module Connection
Theserialconnectionisa12‐pinribboncablethatcontains:
•Fullduplexserialconnection.Thebaudrateis9600,8bits,1stopbit,no
hardwarehand‐shaking.
•Powerfailindicationsignalfromthemeter thattellsthemodu letodisconnect
fromdrawingpowerfromthemeter.
•DCpowerlinewhich
suppliespowertothemodulefromthemeter.
Figure 2.1 Serial connection between module and meter
Endpoint Registration
Aftertheendpointisinstalledinthefield,registeritwiththeUSCHost.Youcan
registertheendpointduringinstallationusingtheUtiliNet2‐Way
ImplementationMangertool,orfromthehost.SeetheUtiliNetSolutionCenter