User Manual

Chapter 8 - T r o u ble sh oo t in g
Landis+Gyr
Network Concentrator User and Installation Guide 98-1013 Rev AF 92
communicate with the CPU. To configure the CPU so it can communicate with the DCW, complete
the following steps:
1. Connect to the CPU using Hyperterm, and then select Y in the Boot screen to boot the unit into
diagnostic mode.
2. Type C.
The EEPROM Configuration menu is displayed for you to verify information.
3. Verify or edit the programmed values for:
• MccNetAddress
• MccNodeAddress
• LogMgrNetAdddress
• LogMgrNodeAddress
• AlarmNetAddress
• AlarmNodeAddress
• MinutesFromGMT
• DayLightSavingsType
Follow the instructions and exit the EPROM menu, booting only if requested by the unit.