User Manual

Landis+Gyr
Chapter 6 - Performing System Upgrad es
Network Concentrator User and Installation Guide 98-1013 Rev AF 68
8. Connect the AC power cable to the concentrator, and plug the other end into an outlet.
Loading the Concentrator Firmware Via Cables Using a Router
Hyperterminal automatically detects the concentrator. If it does not, close the Hyperterminal session,
unplug the concentrator, and start again.
1. Assign the concentrator an IP address.
• In Hyperterminal, specify the COM 1 port and properties as follows:
• Bits per second: 9600 baud
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None.
Figure 6 - 7. Hyperterminal COM port and properties