User Manual

Landis+Gyr
Chapter 6 - Performing System Upgrad es
Network Concentrator User and Installation Guide 98-1013 Rev AF 65
Table 6-1. Download Command Line Switches (continued)
Switch
Description
-disconnect
You need the disconnect session ID if the earlier download
was terminated before completion. In this case, you must
enter all the options of the download command and include
the disconnect session ID. That should be the same
session number that was terminated earlier.
Example: utlICDownload -disconnect 5
-nohotboot
Override automatic disconnect and hotboot to avoid hot
booting the MC be fore the session. In this case, you
must start run disconnect and hotboot.
Example: utlICDownload -nohotboot -session 5 -mccad
30000.1 -s <filename>
-waittime
Time to wait (in seconds) before sending the next packet.
The download firmware process sends a total of nine
packets. The waittime option allows for a delay between
packets sent. Example: utlICDownload -waittime 4
/MCCCTR/image.bin
[Args Reqd: 1 defaults: 2 format: %s]
-bankcopy
Copy Concentrator image from B to A. The Concentrator
must be running the image from B.
This option applies to versions 14.02.06 and greater.
Example: utlICDownload -mccad 30000.1 -bankcopy
-debugprint
Dump raw hex.
Example: utlICDownload -debugprint
[Args Reqd: 1 defaults: 2 format: %s]
-help
Print help information.
Example: utlICDownload -help
-query
Get status of concentrator.
Example: utlICDownload -query
-switchover
Switchover concentrator.
Example: utlICDownload -switchover
Switchover Concentrator
After the download is complete, login to the concentrator to instruct it to switchover.
1. Open a command window on your PC.
2. Use your administrative credentials to login as control user.
3. Type
./utlICDownload -mccad 30000.1 -session 2 -switchover
The concentrator hot boots after this st ep.