User Manual

Network Concentrator User and Installation Guide 98-1013 Rev AF 14
Landis+Gyr Chapter 2 - Pre-Installation
Getting Organized
Concentrator Installation Tool List
• Gas or hydraulic-powered drill, 3/4 inch augur bit
• Two adjustable-end wrenches
• Squeeze-on crimpers and crimps
• Standard socket wrench set
• Laptop computer with two serial ports
• Concentrator and applicable install kit
• Concentrator programming cable
• Network Configuration Manager application
• Concentrator power cable with standard 120VAC outlet
• Survey sheet
• Hyperterminal application
• Personal Protection Equipment
• Voltmeter
• Cell phone or 2-way communication device
Additional Tools Required for Street Light or Traffic Signal Pole Installs
• Steel banding tool
• Tin snips
• Hammer
Additional Tools Required for Building and Structure Installs
• Steel banding tool
• Hammer drill
• Bits
Install Mater i al
The installation process consists of using predetermined route information identifying concentrators
that need to be installed and methods for recording data to document the installation.
From the Cross-Dock, obtain concentrators and installation kits to install.