User Manual

Appendix H - Power Cable Installation
Landis+Gyr
Network Concentrator User and Installation Guide 98-1013 Rev AF 120
Recommendations
Water-Blocking Connections
When 19-227X or 105627-00X cables are used, they do not have to be terminated inside a junction
or disconnect box. Protect the wire junction with mastic tape (or some other method).
In published examples, Collector cables are shown going through conduit. Conduit is not required
for Concentrators.If a junction box is used, the entrance to the junction box should be through a
clamp at the bottom of the junction box. Junction boxes do not have a part number and are available
through local vendors. As always, electrical connections need to meet the requirements of the local
utility and local ordinances.
The figure below shows an installation of a Concentrator without using a junction box.
This installation diagram is for water blocking cable only. Do not install
standard 105704-XXX “old style” cables as shown in the following figure.
Figure H - 2. Suggested Power Termination for Water Blocking Lines