User Manual

E
About Programming and
Diagnostic Cables
Network Concentrator User and Installation Guide 98-1013 Rev AF 113
Landis+Gyr offers multiple cable options for performing system upgrades and configuration. The
following table outlines tasks each cable can perform.
Table E-1. Update Cables
Cable
LPP
Console
Ethernet
19-1185
Do not plug this
cable into a Phase I
Concentrator (26-
1129 or 26-1163).
Upload DCWs,
Upload new
firmware, and
configure the UtiliNet
radio inside the
concentrator.
Configure EEPROM
settings in the
concentrator CPU,
which includes the
Concentrator Net and
Node ID (aka MCC
Net and Node), Event
Manager Net, and
Node settings.
Can do a direct FTP
download of
concentrator CPU
firmware via cable
connection. Use a
router, computer, and
Ethernet cables.
19-1126
Upload DCWs,
Upload new
firmware, and
configure the UtiliNet
radio inside the
concentrator.
Configure EEPROM
settings in the
concentrator CPU,
which includes the
Concentrator Net and
Node ID (aka MCC
Net and Node), Event
Manager Net, and
Node settings.
No Ethernet
connectivity. Perform
upgrades over the air.
You must have a WAN
network setup with a
Take Out Point
(TOP), and the
Cellnet
system running on
the system controller.