User Manual

Table Of Contents

Landis+Gyr

Appendix D - About Firmware

Network Concentrator User and Installation Guide 98-1013 Rev AF 108

Network Parameters Configuration Menu

Option 'n' from the “Diagnostics and Configuration” menu displays the “Network Parameters

Configuration” menu, described in Figure D.3. In this menu, the TCP/IP network parameters are

displayed by using option'd', and the network parameters are configured by using option 'c'.

Figure D.3 Network Parameters Configuration

While configuring, the MAC Address should be set to the MAC address on the Connectcore

processor board. Appropriate values to the IP address, subnet mask, gateway IP address and the

Ethernet settings should be provided, to match the TCP/IP network corresponding to the local IT

environment.

Diagnostics Tests Menu

Option 't' from the “Diagnostics and Configuration” menu displays the “Diagnostics &

Manufacturing Tests” menu. This menu provides several test options. The menu options are

described in Figure 8: Diagnostics and Manufacturing Tests Menu.

Figure D.4 Diagnostics and Manufacturing Tests