User Manual

Landis+Gyr
Appendix D - About Firmware
Network Concentrator User and Installation Guide 98-1013 Rev AF 107
and configuration mode. The details of this configuration are explained in Concentrator Diagnostics
Mode. The following figure describes boot-up.
Figure D.1 Boot Up
Diagnostics Mode
During the startup, the following question displays on the console:
Boot up to Diagnostics Mode ...? (y/n)y
If the input is 'y', the concentrator goes into diagnostics mode. The diagnostic mode has limited
functionality. The WAN port and the LAN port are not activated in this mode. This mode helps the
user to:
• Configure the concentrator;
• Browse and capture the Ramlog; and
• Perform diagnostics tests.
Diagnostics modes are described in the following sections.
Diagnostics Mode
The diagnostics mode provides more diagnostics. In addition, this mode provides option to configure
the TCP/IP Network Parameters.
Figure D.2 Diagnostics Mode