User Manual
Table Of Contents
- 10-0097 - Manual Cover.pdf
- Concentrator Manual 98-1031-1
- Table of Contents
- Preface
- Pre-Installation
- Field Configuration
- Concentrator Installation
- RF Filter Enable/Disable and Battery Replacement Kit
- Performing System Upgrades
- Troubleshooting
- Product Specifications
- Compliance
- Bench Testing
- About Firmware
- About Programming and Diagnostic Cables
- Sample Survey Sheet
- Power Cable Installation
- Glossary
- Index
Landis+Gyr Appendix D - About Firmware
Series IV Concentrator U and I Guide 98-1031 Rev AA 91
and configuration mode. The details of this configuration are explained in Concentrator Diagnostics
Mode. The following figure describes boot-up.
Figure D.1 Boot Up
Diagnostics Mode
During the startup, the following question displays on the console:
If the input is 'y', the concentrator goes into diagnostics mode. The diagnostic mode has limited
functionality. The WAN port and the LAN port are not activated in this mode. This mode helps the
user to:
• Configure the concentrator;
• Browse and capture the Ramlog; and
• Perform diagnostics tests.
Diagnostics modes are described in the following sections.
Diagnostics Mode
The diagnostics mode provides more diagnostics. In addition, this mode provides option to configure
the TCP/IP Network Parameters.
Figure D.2 Diagnostics Mode
Boot up to Diagnostics Mode ...? (y/n)y