User Manual
Table Of Contents
- 10-0097 - Manual Cover.pdf
- Concentrator Manual 98-1031-1
- Table of Contents
- Preface
- Pre-Installation
- Field Configuration
- Concentrator Installation
- RF Filter Enable/Disable and Battery Replacement Kit
- Performing System Upgrades
- Troubleshooting
- Product Specifications
- Compliance
- Bench Testing
- About Firmware
- About Programming and Diagnostic Cables
- Sample Survey Sheet
- Power Cable Installation
- Glossary
- Index
Landis+Gyr Chapter 6 - Performing System Upgrades
Concentrator User and Installation Guide 98-1031 Rev AA 67
G. Type bye.
Figure 6 - 17. C:\bye
Figure 6 - 18. Ramlog read successful message
4. Boot to Diagnostics Mode by typing y for yes in the Hyperterminal window.
5. Update the image.bin file.
A. Open a command prompt window, usually under Start | Programs | Accessories.
After a few seconds, Hyperterminal displays messages to confirm a successful
restart. When you see the message “Ramlog Read Successful,” you can
continue with the programming process.