User Manual
Table Of Contents
- 10-0097 - Manual Cover.pdf
- Concentrator Manual 98-1031-1
- Table of Contents
- Preface
- Pre-Installation
- Field Configuration
- Concentrator Installation
- RF Filter Enable/Disable and Battery Replacement Kit
- Performing System Upgrades
- Troubleshooting
- Product Specifications
- Compliance
- Bench Testing
- About Firmware
- About Programming and Diagnostic Cables
- Sample Survey Sheet
- Power Cable Installation
- Glossary
- Index
Landis+Gyr Chapter 6 - Performing System Upgrades
Concentrator User and Installation Guide 98-1031 Rev AA 61
8. Connect the AC power cable to the concentrator, and plug the other end into an outlet.
Loading the Concentrator Firmware Via Cables Using a Router
Hyperterminal automatically detects the concentrator. If it does not, close the Hyperterminal session,
unplug the concentrator, and start again.
1. Assign the concentrator an IP address.
• In Hyperterminal, specify the COM 1 port and properties as follows:
• Bits per second: 9600 baud
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None.
Figure 6 - 7. Hyperterminal COM port and properties