User Manual
Table Of Contents
- 10-0097 - Manual Cover.pdf
- Concentrator Manual 98-1031-1
- Table of Contents
- Preface
- Pre-Installation
- Field Configuration
- Concentrator Installation
- RF Filter Enable/Disable and Battery Replacement Kit
- Performing System Upgrades
- Troubleshooting
- Product Specifications
- Compliance
- Bench Testing
- About Firmware
- About Programming and Diagnostic Cables
- Sample Survey Sheet
- Power Cable Installation
- Glossary
- Index
Chapter 6 - Performing System Upgrades Landis+Gyr
60 98-1031 Rev AA Concentrator User and Installation Guide
Connecting to the Concentrator Via Cables Using a Router
If you would like to be able to access the intranet from your PC while programming the concentrator,
then set up the cables using a router.
It enables you to share one intranet connection with your PC and your concentrator simultaneously.
Figure 6 - 6. Diagram of router cable setup
1. Connect the programming cable branch (labeled “Console”) to the concentrator.
2. Connect the ethernet branch (labeled “Ethernet”) to the router.
3. Plug your network cable into the router.
4. Connect the router to the network port on the PC via network cable.
5. Connect the other end of the programming cable to the COM port on the PC.
6. Launch Hyperterminal on the PC.
7. “Boot Up in Dialog”, type y for yes.
Use a router to perform this procedure. This procedure is not designed to work
with a switch.
Do not plug the LPP branch into the PC.
Launch Hyperterminal before supplying power to the concentrator.